Cheap Carbon Face Seal Manufacturers – W2100 Elastomer Bellow Mechanical Seal Replacement of John Crane 2100 – VICTOR SEALS

Features

Unitized construction allows for fast and easy installation and replacement. Design fits DIN24960, ISO 3069 and ANSI B73.1 M-1991 standards.
Innovative bellows design is pressure-supported and will not crease or fold under high pressure.
Non-clogging, single-coil spring keeps seal faces closed and properly tracking during all phases of operation.
Positive drive through interlocking tangs will not slip or break free during upset conditions.
Available in the widest array of material options, including high performance silicon carbides.

Operation Range

• Completely assembled one-piece design for fast installation
• Unitized design incorporates positive retainer/key drive from bellows
• Non-clogging, single coil spring provides greater dependability than multiple spring designs. Will not be affected by build-up of solids
• Full convolution elastomeric bellows seal designed for confined spaces and limited gland depths. Self-aligning feature compensates for excessive shaft end play and run-out

Operation Range

Shaft diameter: d1=10…100mm(0.375” …3.000”)
Pressure:  p=0…1.2Mpa（174psi）
Temperature:   t = -20 °C …150 °C(-4°F to 302°F)
Sliding velocity: Vg≤13m/s（42.6ft/m）

Notes: The range of pressure, temperature and sliding velocity is depend on seals combination materials

Combination Materials

Rotary Face
Carbon graphite resin impregnated
Hot-Pressing carbon
Silicon carbide (RBSIC)
Stationary Seat
Aluminium oxide (Ceramic)
Silicon carbide (RBSIC)
Tungsten carbide

Elastomer
Nitrile-Butadiene-Rubber (NBR)
Fluorocarbon-Rubber (Viton)
Ethylene-Propylene-Diene (EPDM)
Spring
Stainless steel (SUS304, SUS316)
Metal Parts
Stainless steel (SUS304, SUS316)

Applications

Centrifugal pumps
Vacuum pumps
Submerged motors
Compressor
Agitation equipment
Decelerators for sewage treatment
Chemical engineering
Pharmacy
Paper making
Food processing

Mediums: clean water and sewage, mostly used in industries such as sewage treatment and papermaking.
Customization: Changes of materials for getting other operating parameters are possible. Contact us with your requirements.

W2100 DIMENSION DATA SHEET (INCHES)

DIMENSION DATA SHEET (MM)

L3= Standard seal working length.
L3*= Working length for seals to DIN L1K (seat not included).
L3**= Working length for seals to DIN L1N (seat not included).